All Prices shown are in AUD and include Australian GST, if you are an international customer this will be deducted at Checkout.

The new Solo2 receives the data from two satellites constellations, GPS and Glonass: this is a huge step forward since it is unbelievably faster and more precise than the previous version. 
The power ON requires only a few seconds and the lap times are calculated with a max 2/100 sec of tolerance.

Find your track easily and quickly

Solo 2 can rely on a database of more than 3,000 tracks all over the world: as soon as it switches on, Solo 2 identifies its position, recognizes the starting line coordinates of the track and starts sampling lap times.

In case the track is not in the database, no problem: Solo 2 realizes it and enters into the autolearning mode, automatically understands the characteristics of the track and gives the lap time anyway.

Even the predictive lap time is much more reliable, and the configurable RGB LEDs will give you a clear and fast indication of the comparison with your best lap.

Race Mode Selection

Solo 2 can manage different types of races:

- Speed races in a closed circuit

- Point to-point races

- Regularity

In each of these configurations, Solo 2 gives the proper information during the test and powerful data review immediately after each session. More than 1,000 protocols for 1,000+ ECU in the database, to easily connect your Solo 2 DL to your Engine Control Unit and get a lot of information with just one cable.

In case your ECU protocol is not in the database, no problem: an ECU Driver Builder is always available in the Race Studio 3configuration software, and you will be able to create your protocol by yourself.

Coil RPM input
Solo 2 DL now features a digital input allowing to log RPM either from square wave signals (8-50 V each signal) or pulse signals (150-450 V ignition coil trigger – primary circuit).